In a piping system, a bend is a pipe member that changes the direction of the line. According to this Angle, there are three common elbows: 45° and 90°180°. In addition, depending on the needs of the project, other shapes of the elbow are included, such as 60°. Elbow materials include cast iron, stainless steel, alloy steel, California cast iron, carbon steel, non-ferrous metals and plastics.
The way of connection with the pipe: direct welding (ordinary) flange connection, hot melt connection, electric melt connection, thread connection, socket connection, etc. According to the production process can be divided into: welded elbow, stamping elbow, push, cast elbow, welding and other names: 90 degree elbow, right Angle elbow, etc.
A elbow is a connection pipe used to connect and change the direction of the pipe in a water heater installation.
Other names: 90° elbow, Right Angle elbow, Love bend, stamping elbow, stamping elbow, mechanical elbow, welding elbow, etc.
Usage: Two nominal diameters are connected with different tubes, allowing the tubes to rotate at 90°, 45°, 180° and at different angles.
The bend of the pipe diameter is less than or equal to 1.5 times the pipe diameter. The bend belongs to 1.5 times the pipe diameter.
A connecting pipe for pipe installation is connected to two nominal diameters and allows the pipe to rotate at an Angle and has a nominal pressure of 1-1.6MPa.
1. Since most tubes are welded to improve the quality of welding, the end is inclined, with a certain Angle and a certain edge. This request is also popular. There are many sides, specifying how many angles and deviation ranges. The surface quality and mechanical properties are basically the same as those of pipes. In order to facilitate welding, the pipe joint has the same amount of steel as the connecting pipe.
2. All tubular components that should be surface treated, the surface of the outer surface and the outer surface should be sprayed and laminated. This is derived. Also, to facilitate transport, we need to do this at home to facilitate transport and oxidation.
That is to say, for small pipes, if you want to export, you need to make a wooden box, about 1 cubic meter. It is stipulated that the number of elbows in this frame should not exceed one ton. This standard allows us to fit, i.e. large sets, but the total weight should not exceed one ton.
